Getting my internal flash fixed on 5050

[Gizmo]

Originally Posted by TimIngmire

Mark, I have a few other bits and peices that I'm no longer using inc tray, handle, WAL and lens dock (for you you're not using the WAL underwater).

I'll bring it all on Saturday.

Tim

Sorry I missed you Saturday, I asked around for you but I think you left when I was in the water

Mark

[TimIngmire]

Hi Mark,

Likewise I was also asking around but with no luck. Are you going to be at Stoney anytime soon?

[Gizmo]

Originally Posted by TimIngmire

Hi Mark,

Likewise I was also asking around but with no luck.* Are you going to be at Stoney anytime soon?

Not in the immediate future but I travel a fair bit for work. Incoming PM

[Gizmo]

Originally Posted by TimIngmire

Mark, I would never drill a hole into any housing - its more than I would risk.

Yep, the third way is dead simple because of the clear housing, you have a little emitter that sits in your hot shoe and send a signal to a receiver that you attach to the outside of the housing - This receiver takes a standard cable (in my case a Sea and Sea Nikonos type) which is attached at the other end to my Inon Strobe.* All very clever.

Are you at the Stoney YD meet this Saturday?* If so then I can show you there.

Tim

Tim do you have a picture of how you attached the IR receiver to the outside of the housing?

Mark

[TimIngmire]

Hi Mark,

I don't have a picture but the adaper is tie-wrapped to the post on the flsh diffuser with the end that you plug the lead into pointing forward. Make sure that the adapter can see the emitter in the hotshoe.

I'll see if I can find a picture elsewhere.

If this doesn't help let me know.

Cheers,
Tim